Error messages, Cause & remedy, Troubleshooting guide – Panasonic KXF120 User Manual
Page 50
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Troubleshooting Guide
Error Messages
CHECK COVER
Cause & Remedy
If the message appears, close the cover again carefully.
OUT OF PAPER
When the recording paper is finished, replace it.
POWER FAILED
•When the AC cord is plugged.
•If a power failure occurs, this message will appear after the power is
restored.
BATTERY LOW
If this message appears, the batteries have become weak and should be
replaced.
CHECK OGM/BATT.
CHECK MEMORY
•The batteries should be replaced, since they are discharged.
•The OGM should be re-recorded and the present time should be
reprogrammed, since they are erased.
If this message appears, Phone/Fax numbers and your selections are
erased, since the built-in lithium battery has become weak. Consult with
specified Panasonic Factory Servicenter.
SORRY, NO ANSWER
When the document does not transmit.
Try again.
CHECK DOCUMENT
WAIT, OVERHEATED
CHECK ICM TAPE
•When you transmit a document which is longer than 600 mm, this
message will appear. (The alarm may sound.) Open the cover and
remove the document.
•If a document is jammed during transmission, this message will appear.
Open the cover then remove the jammed document.
When copying or receiving documents for a long time, the unit may
overheat. (The ALARM indicator will light.) In this case, leave the unit
alone and allow the unit to cool.
ICM tape is full. Push the REW button to reset the tape or use 2-side of the
tape.
4-2