Panasonic NV-F55EA - Manual (Page 9)

Infra-Red Remote Controller (Cont’d)
Power Source for the Remote Controller
■ The Remote Controller is powered by 2 lEC “R6” size
batteries. The life of the batteries is about one year,
however, it depends on the frequency of use. Inspect
and if necessary, replace the batteries once a year.
CAUTION FOR BATTERY REPLACEMENT
• Load the new batteries with their polarities (© and 0)
aligned correctly.
• Do not apply heat to batteries, or internal short-circuit
may occur.
• If you do not intend to use the Remote Controller for a
long period of time, remove the batteries and store them
in a cool and dry place.
• Remove spent batteries immediately and dispose of
them.
• Do not use an old and a new batteries together. (Also
never use an alkaline battery with a manganese battery.)
Load the batteries as follows:
1 Remove the battery compartment lid.
Remote Control Modes
2 Place the batteries in the battery compartment as
indicated inside the battery compartment.
3 Replace the lid.
This VTR can be remote controlled with two types of
signals. These signals are called Remote Control Mode
"VTR rand “VTR 2“.
When the Remote Control Mode Select Switch on the VTR
is set to “VTR 1 the Remote Control Mode Select Button
on the Remote Controller must also be set to “VTR 1
When using two Panasonic VTRs
Remote Control Mode Remote Control Mode
“VTR r “VTR2 '
=|l! II ll«!-! 1, SIT t ' Ti|ori 1]
----------- \------------------
__
0 C О
О О О
1
- О о 1
0 о о ! .
О G с
с о е
О С С О
о О с с
1 О О О о
с О О с
1 G о О о !
с о 1
Г ,0 о ,1
^ --
When the Remote Control Mode Select Button on the
Remote Controller Is set “VTR 1 the VTR on the left can
be operated. When the Remote Control Mode Select Button
is set to “VTR
2 " , the VTR on the right can be operated.
• “VTR 2“ will appear in the Display.
In case of VTRs with switchable remote control modes, set
a different remote control mode for each of the VTRs so that
they can be operated individually with the same Remote
Controller.