Press [disc – Panasonic SC- AK54 User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Program play
by remote control only
You can program up to 24 tracks,
El Press [CD].
Ensure CD is stopped.
Press [PROGRAM].
Press [DISC].
□
(within 10 seconds or so)
Press [1] - [5] to select the disc you want.
Press the numeric button to select the desired track.
□
Repeat steps Q through Q until you have pro
grammed all the tracks you want.
□
Press [►/A].
Play will start in the programmed sequence.
* •
To cancel program play mode
Press [PROGRAM] in the stop mode.
Programmed contents will be saved in memory.
Pressing [■/ CLEAR] will cancel program play, but it will also erase
the entire program.
To select a two-digit track
Press [>10] and then the two numbers you want.
Q When “CD FULL” appears
The number of programmed tracks is limited to 24. No further
tracks can be programmed.
El You can do the following during program mode
• Check program contents.
Press
or [►►/►N],
Every time you press one of the buttons, the track and program
No. are shown on the display.
• Add to the program.
Repeat steps Q through Q.
• Cancel entries.
I
I
T>
}
From the last
programmed track
Press [CANCEL],
A specified track
only
Select the track with or
[►►/►►1], and press [CANCEL] within
3 seconds.
All tracks
Press p/CLEAR],
Memory retention
Your program is retained in memory for about 2 weeks while the
system is unplugged.
To replay your program
If you turned OFF your program with [PROGRAM], you can play it
again as explained below.
1. Press [PROGRAM].
2. Press [►/A],
If you program a track not on your CDs
The track is initially programmed, but during program play, the player
will skip that track and will continue playing from the next programmed
item.
RQT5666