Panasonic PV-7451 - Manual (Page 18)

Timer Recording
You can set up the VCR to record a one
time, daily, or weekly program while you
are away or otherwise occupied. Up to 8
programs can be stored in memory.
I^jfcheck list before you begin.
n All connections are made.
(See pages 6-9.)
□ TV and VCR are plugged in and turned on.
□ VCRm/ selector is set to “VCR."
□ Clock is set to correct time.
□ Record tab in place. (See page 5.)
Multi Function Display
(
3
)
о
Push PROG to display
the “SET PROGRAM"
screen.
Push
AT
to select
“TIMER PROGRAM,”
and then push ► to
display the program
screen.
If a program is already in memory,
push
AT and ^ to select an unused
program number.
SET PROGRAM ---
VCR PIU8+ PROGRAM
TIMER PROGRAM
SELECT: A т KEY
SET :► KEY
END :PROG KEY
START STOP CH
ELECT START DATE
SELECT
SET
END
A T KEY
► KEY
PROG KEY
i Push
AT
and ► to select and
set one of the following:
• 1-31 =One time recording
• DAILY =Same time MON-FRl
Example
Today’s
Date
WEEKLY =Same time once a week
^8—9'*.........'31—1 —2.......... '6
7 SELECTA t T Selection Order
(^WEEKLY ......WEEKLY WEEKLY J
DAILY
(SAT) (MON) (SUN)
Push
AT
and
to select and set
each of the remaining
items at right.
To Make Corrections
Repeatedly push ► to move the cursor to the right,
or ^ to move to the left to the incorrect entry and
make the correction.
Remaining Items
to be set:
• START time
• STOP time
*CH(annel) number,
or LINE for outside
source recording
• Speed (SP, LP. SLP)
' Push PROG to end
^ : the program.
. • This screen appears for
confirmation.
To Enter More Programs
Push AT and ► to select and set a blank
program number, and then repeat steps 3 and 4.
P DT START STOP CH SPD
1DAY g:00A12;00A 08 SP
CANCEL:ADD/DLT KEY
SELECT 1-8:A ▼ KEY
ENTER :► KEY
END :PROG KEY
О
Push PROG to exit this
mode and return to the
normal screen.
Important notes when using a
DSS receiver
• When recording programs via a DSS
receiver, the DSS receiver must be
left on.
• When recording programs via an
antenna or cable, the DSS receiver
must be turned off.
Push POWER off
to set the timer.
• When recording programs via
a cable box, make sure the
cable box is left ON and
tuned to the desired channel.
Multi Function Display
18
A cassette with no record tab is ejected and TIMER indicator flashes when the power is turned off to set the timer.
If the start times of two programs overlap, the lower numbered program will have priority.
If the start time for a timer recording comes up during a normal recording or One Touch Recording (page 16),
the timer recording will not be performed.
If there is a power interruption of more than one minute, the recording will not be performed or continue.