Leica Geosystems RCS1100 Series - Manual (Page 40)

40 Safety directions RCS1100-1.2.0en
5
7
6
Only for RCS1100 without integrated radio
modem:
FCC statement (applicable in U.S.)
WARNING:
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit diffe-
rent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
WARNING:
Changes or modifications not expressly
approved by Leica Geosystems for compliance
could void the user's authority to operate the equipment.
Product labelling:
Tcs1
1z03
Type: RCS1100
Art.No.: .667173
Power: 12V/6V ---,
0.4Amax; EPR:100mW
Leica Geosystems AG
CH-9435 Heerbrugg
Manufactured: 2002
Made in Switzerland S.No.: #$1#
This device complies with
part 15 of the FCC Rules.
Operation is subject to
the following two
conditions: (1) This
device may not cause
harmful interference, and
(2) this device must
accept any interference
received, including
interference that may
cause undesired
operation.
This device
contains a
transmitter:
FCC ID:
HSW-2400M
SSDL-1
!