Leica Geosystems RCS1100 Series - Manual (Page 11)

11
RCS1100-1.2.0en Preparation,Setting up
6
Switch on the RCS Mode on TPS1100/ TPS1000
Setting the interface on the
TPS1100:
MAIN\ Main menu
MC
MAIN\ Configuration
MC
MAIN\ Communication mode
MAIN MENU: PROGRAMS
MC
EXTRA\ EXTRA FUNCTIONS
MC
EXTRA\ EXTRA FUNCTIONS
Switches to Remote Control
mode.
Do you want to switch ?
TPS1100/TPS1000 interface parameters
Setting the interface on the
TPS1100:
MAIN\ Main menu
MC
MAIN\ Configuration
MC
MAIN\ Communication mode
MAIN\ RCS parameters
The interface parameters on the TPS1100 / TPS1000 must be inspected and
if necessary adjusted to the those for the TCPS26, which were set in the
factory to the following values:
19200 baud
8 data bits
No parity
Setting the interface on the
TPS1000:
Set the following values
19200 baud
8 data bits
No parity
The remaining values are not rele-
vant.
Set the following values:
19200 baud
8 data bits
No parity
For details, refer to the TPS1000
Systems Handbook.
MAIN MENU: PROGRAMS
MC
CONF\ SYSTEM CONFIG.
MC
CONF\ GSI-COMMUNICATION
Confirm with "YES".
Setting the interface on the
TPS1000:
Confirm with "YES".
MAIN\ RCS mode
Switches to Remote Control
mode.
Do you want to switch ?