Dillon EDXtreme (Red) - Manual (Page 56)

EDXtreme User Instructions 55
Place spacer on a solid surface and use a hammer to start the roll pins into the two
small spacer holes. See Figure
7.2 .
Figure 7.2 Inserting Roll Pin
Insert through matching holes in dynamometer body. Lay the dynamometer on the
spacers on a solid surface with the roll pins protruding from the top. See Figure
7.3 .
Figure 7.3 Roll Pins Extending Above Dynamometer Body
Position the holes of the second spacer over the holes and tap spacer into position. See
Figure
7.4 .
Figure 7.4 Placing Second Spacer on Roll Pins
A punch sized slightly smaller than the holes in the spacer may be helpful. The spacers
should “sandwich” the dynamometer body, but should not be drawn completely tight.
Remove the four large circular foam plugs from the carry case and it can continue to
be used with the spacers attached.