Dillon EDXtreme (Red) - Manual (Page 23)

22 EDXtreme User Instructions
3.4 Log Mode
Log mode is used to log/record force and peak data. This can be done on each lift,
during a timed duration, during an overload or on Print key operation.
Press the appropriate soft key shown in Figure 3.1 to accomplish the functions listed
on the following pages.
Setup Setup allows the user to configure how the EDXtreme stores data
internally. This stored data can be downloaded via the 4 pin Lemo (CELL
port on the EDX) to a PC via a keyboard wedge or other device.
Log Mode:
Disable: Turns the log feature off.
On Print: Used when the operator wants to do a lift and
store of the force and peak.
Auto ID Increment: Enable/Disable
This will increment the ID by 1 every time the
"PRINT" key is pressed and store it with each
force and peak.
Auto ID Prompt: Enable/Disable (will only appear
if Auto ID Increment is Disabled)
If "Enabled", the operator will be prompted to key
in an ID before storing that ID with the force and
peak.
Comm Port:
This allows you to choose where to export the
"ON PRINT" logged data.
a. EDX = Cell
b. COMM = Com1
c. RADIO = Future development
d. Disabled = to turn off
On Lift: Used when the operator wants the load to be
automatically stored, once the load becomes stable. Note:
additional filtering may be required, as the load must be
steady before the load will be recorded. Maximum
Records = 255
Threshold %: (based on capacity)
This is the load above where the unit will record
the stable load.
Re-arm: (based on capacity)
This is the load the force must drop below before
the "ON LIFT" will reset (re-arm) and store
another load.