Dillon EDXtreme (Red) - Manual (Page 22)

EDXtreme User Instructions 21
3.3 Displaying Peak Force
The EDX will store the peak force applied until that reading is cleared. To display the
peak force applied to an EDX, from the force measurement mode, press the Mode soft
key. The display changes to display menu #2 shown in Figure
3.2 which is the peak
display mode. The peak force is displayed. You can clear this by pressing the Clear soft
key.
Peak reading is maintained after the instrument is powered off and will be recalled with
the next power-on. Peak reading may be lost if battery power is removed.
Figure 3.2 Display Mode Menu
Press the Mode soft key repeatedly until the desired display mode is reached.
Display #2 Mode
Mode key
press
Mode key
press
Live force
reading
Display Mode #1
Force Force lbf lbf 0 0
Mode Config Setup Print Clear Units
Arrow key
press
ESC key
press
Log
Peak force
reading
Peak Peak lbf lbf 0 0
Mode Setup Config Print Clear Units
ESC key
press
Arrow key
press
Log
Display #3 Mode
Dual display
Live & Peak
Force Force
Peak Peak
lbf lbf
0 0
0 0
Mode Setup Config Print Clear Units
ESC key
press
Arrow
key press
Log