Dillon EDXtreme (Red) - Manual (Page 20)

EDXtreme User Instructions 19
3 EDX Operation
The EDXtreme uses a menu system to perform specific functions or make changes to
the configuration. Refer to
Figure 3.1 for the user menu diagram.
Figure 3.1 User Menu
Units Press the Units key to choose one of the following units; lbf, kgf, N.
Print Press the Print key to send to a peripheral device such as a printer, remote
display or computer. (Also used to start and stop when using “Timed”
under Log.
Mode Press the Mode key to select between force, peak or force/peak modes.
Clear Press the Clear key to clear the Peak weight.
Log Press the Log key to configure and view data logging settings. See section
3.4 .
Setup Press the Setup key to access the Setup menu and configure logging
function.
Config Press the Config key to access the Configuration menu.
3.1 Display Modes
The EDX has several display modes accessible by pressing the Mode soft key. See
Figure
3.2 .
The first display mode when you power up is the live force measurement mode.
Press
Arrow
Key
Units Print Mode Clear Log
Setup ID Send Clear
Log Mode
Disable On Print On Lift Timed Overload
Auto ID increment
(Enabled,
Disabled)
Auto ID prompt
(Enabled,
Disabled)
Log rate (sec)
1
Log count
(1 to 255)
Auto send
(Disabled,
Enabled)
Comm port
(Disabled, Cell,
COM1, RADIO)
Threshold%
10
Re-arm%
2
Auto ID increment
(Enabled,
Disabled)
Threshold%
5
Re-arm%
2
Holdoff Seconds
1
Comm port
(Disabled, Cell,
COM1, RADIO)
Comm port
(Disabled, Cell,
COM1, RADIO)
Setup Config
See Config
section
See Setup
section
ONLY APPEARS
IF AUTO ID
INCREMENT IS
DISABLED
Comm port
(Disabled, Cell,
COM1, RADIO)