Daiwa TANACOM 1000 - Manual (Page 33)

Nut
Collar
Rod Clamp
rod
31
How to fix the Rod Clamp
1. Insert the Bolt in the clamp setting hole, and fix it by tightening
the Nut and the Washer.
2 . Hold the rod in position while attaching the clamp.
Tighten the rod clamp nuts to secure.
1
2
Attention
- If the Nut is tightened too firmly, there is a danger of deforming the rod depending upon
rod material, especially with composite rods and reel seats.
When you use a metallic bat or for your fishing of a big charge, you should always utilize the Rod
Clamp.
(sing the Rod Clamp, it is possible to cramp rods with diameter up to 25-34mm)
Bolt
Nut
Washer
Wrench Tighten
To fix the reel with a rod clamp apply the screws to the reel foot
then place the rod between the threads then add the clamp and
tighten the nuts.
*Use the collar only on a rod 25 mm or
less in diameter.