Daiwa TANACOM 1000 - Manual (Page 23)

21
4. Press the MODE BUTTON to go back to depth readout.
1
2
4
2. Press MODE BUTTON again.
3.
Set speed with the power lever.
1. Press MODE BUTTON .
Pickup speed preference
If the display is at display, then move the power lever or
press RESET BUTTON to show the display shown on the right.
This display is the pickup setting display.
Use
While the power lever is at MAX position,
pressing the PICKUP BUTTON makes the
motor run at the pre-set pickup speed.
Attention
1. While the PICKUP BUTTON is in use for winding, winding speed is not displayed.
(the figure corresponds
to the case of setting to 5)
Functional setting operation
(5. Pickup speed setting)
3