Line data input (with backing line), With backing line---------------------(p2), Line data input – Daiwa TANACOM 1000 User Manual
Page 14: With backing line)
12
Line data input
(With backing line)
This method requires use of Daiwa braided line that is color coded to show length and has a total
length greater than 100 m.
1
OFF
2
5.
Press the
MODE BUTTON
twice and change the display to
backing line input.
P2
will then be blinking.
Levelwind Guide
Main line
Main line
Pin
Power lever
3
4
5
Backing line
Tie
1.
Run the backing line through the levelwind guide and tie it onto
the spool. The levelwind threader makes this process easier.
Make sure to tie the line onto the pin found on the spool to
avoid the line slipping.
2.
Wind the backing line.
If the power lever is not already at OFF position, then pull it
back to OFF position before beginning to wind.
3.
Tie the backing line securely to the main line.
4.
Press the
MODE BUTTON
for 5 seconds, when the display will
show
0.0
.
P1
will be blinking.