Line data input (backing line 2), Backing line 2--------------------------(p3), Line data input – Daiwa TANACOM 1000 User Manual
Page 16: Backing line 2)
14
Line data input
(Backing line 2)
This procedure is to enter the line length after it has been wound onto the reel. It is necessary that
you know the line length and that it is greater than 100m.
2
3
5
4.
Paying attention to the line’s color coding, pull 50m of line off of
the spool.
1.
Connect the battery to the reel.
2.
Press the
MODE SET BUTTON
for 5 seconds, changing the
mode to
P1
.
3.
Press the
MODE SET BUTTON
2 more times and set the
mode to backing line 2.
This mode shows
P3
blinking on the low left of the display.
5.
Press the
RESET BUTTON
for 2 seconds.
This will show the digits
100
in the lower area of the counter.