Daiwa TANACOM 1000 - Manual (Page 21)

19
1.5m
3
1
2
Auto stop setting
The Auto stop depth may be set to meet your own specific needs.
1. Connect the reel to the battery, and press the RESET BUTTON
with your terminal rig at the surface.
The display shows 0.0 .
- Auto stop adjusts to operate at depths from 1 m to 5 m (in 10 cm increments).
- It prevents accidentally winding swivels, terminal rigs etc. into the rod tip and stops your rig at a consistent depth
for convenient checking and changing of baits and sinkers.
- Line stretch can cause an inaccurate reading at the surface. Simply reset the counter to zero at the surface.
3. After adjusting length, press the INVERSE COUNTER
BUTTON for 2 seconds.
When blinks, this procedure is completed.
Default setting is 2.0 m. (Without pressing the RESET BUTTON
the winding stops at a depth of 5.0 m.
The lamp will blink when the setup has been completed.
4. When checking or changing a bait, simply wait until the reel
automatically stops winding and raise the rod tip.
Use
Checking and changing sinkers, baits etc.
Functional setting operation
(3. Auto stop function)
Auto stop
Auto stop automatically brings your terminal rig to the surface, stopping consistently at your
pre-set depth preference. It eliminates the need to constantly monitor depth as it comes up.
- The auto stop function assists when winding with the power lever, jigging, or winding with the chumming timer.
- After the rig is ready, reset the depth counter to zero by pressing the RESET BUTTON .
(water surface zero setting) (After this, appears on the display)
- Without pressing the RESET BUTTON , winding stops at a depth of 5 m.
- If you have pressed the RESET BUTTON , the alarm sounds at 2m increments above the depth of 8 m, and
winding stops at 2 m.
- When auto stop depth is set, the alarm sounds every 2 m above the depth of 6 m, and winding stops at the set depth.
- After auto stop stops winding, the power lever can be used up to 0.0 m. However, above 0.0 m, motor winding
such as, power lever and PICKUP, cannot be employed until the RESET BUTTON is pressed.
- Depending upon the rocking of the boat or sinker weight, auto stop depth can overrun slightly. Should this
happen, increase the depth of the auto stop.
2. Raise the rod and adjust the line length from the rod tip so you
can reach the rig easily. In the figure, its length is 1.5 m.