Daiwa TANACOM BULL 750 - Manual (Page 26)

24
5.
Clutch OFF (spool unlocked) to send the rig to the bottom.
(After water surface zero setting, see page 20.)
Inverse counter
OFF
Two counters are better than one. This reel has counters from both the surface and from the bottom.
-As the default setting of the inverse counter, it displays the measured winding speed during electrical winding.
If you want to use it as the inverse counter as in the previous model, turn on the inverse counter (See page 28).
In the following example, intended fishing range is 94 m, which is 6 m from the bottom.
5
6. At the bottom or when desired length of line is wound out,
move the clutch to ON by turning the reel handle or flipping the
clutch lever with your hand.
7.
At the bottom, after winding up any slack line, and when the
desired length of line is wound out, press the INVERSE
COUNTER BUTTON to display 0.0 on the lower counter. You
will be able to know the position of the rig in relation to the
position you set with the counter. (The figure shows that it is at
6 m above the position you have set as zero.)
8. To pull up fish or the rig, you can stop the electric winding
automatically by setting any desired speed with the power
lever.
Use
-By pressing the INVERSE COUNTER
BUTTON, the timer starts and keeps an
accurate record of fishing time.
-You can wind the line electrically while pressing
the PICK UP BUTTON .
ON
7
Functional setting operation
(6. Inverse counter)