Daiwa TANACOM BULL 750 - Manual (Page 14)

12
Attention
1.Do not allow line to rub against the finger guard while winding as it will scratch the guard.
2. The motor can be overloaded when winding at very high tension for a long time (about 15
minutes). In this case, the motor will automatically stop. This does not occur while fishing
as water helps cool down the motor. If the motor stops, wind manually or move the
power lever momentarily back to OFF and then resume winding. Wind the line at high
speed (less tension).
Line data input
(When line length is known---P1)
This method is used when the line length is known before winding. In the example below,
PE 6 – 700m is wound.
1. Run line through the levelwind guide and tie it onto the spool.
The levelwind threader makes this process easier. Make sure to
tie the line onto the pin found on the spool to avoid the line
slipping.
4
MAX
1
4. Push the power lever forward to maximum and wind the line to
its end.
As the power lever is moved forward, the P1 display changes to a
tension indicator. Keep line tension between level 5 and 7 while
winding on line.
2.
Move the power lever to the OFF position.
3.
With the reelʼs power on and the display showing 0.0 , press the
MODE BUTTON for more than 5 seconds.
Make sure the drag is set firmly.
3
Tension indicatar
Levelwind Guide
Main line
Pin
Power lever
2
Note that the value of tension between 5 and 7 simply displays an
appropriate value with the power lever at MAX. When wound at a
low speed, the display shows that a high tension is applied, so
please be careful since it may cause trouble.