Daiwa TANACOM BULL 750 - Manual (Page 17)

15
11. Press RESET BUTTON for 2 seconds and 0.0 will appear.
This is the end of the procedure.
11
7
9
6
MAX
Attention
1.Do not allow line to rub against the finger guard while winding as it will scratch the guard.
2. When the line is wound indoors for a long time (15 min. or more) at a high tension, the
motor may heat up abnormally and cause problems, such as deterioration of winding
power, speed, etc., so electric winding is stopped automatically. Input line at as a high
speed as possible. When actually fishing, there will be no problem because it is cooled
down with sea water, etc. When it stops, wind up manually or pull the power lever back
up and down again towards the MAX side to rewind it and re-input line.
6. As indicated by the lineʼs color coding, wind the line up until the
remaining line is 100m.
With the power lever moved forward, P2 changes into a tension
indicator.
Adjust the tension to between 5 and 7 on the right side of the
panel.
7.
Press RESET BUTTON for 2 seconds.
P2 blinks again and the lower counter shows 50 . The upper
counter digits increase as line is wound.
8. Wind on another 50 m of line, keeping line tension at the
suggested level.
(Be careful not to wind up excessively.)
-Note that the value of tension between 5 and 7 simply displays
an appropriate value with the power lever at MAX. When wound
at a low speed, the display shows that a high tension is applied,
so please be careful since it may cause problems.
9. Press RESET BUTTON for 2 seconds.
The lower counter shows 100 .
10. Wind the remaining 50m, keeping line tension at the
suggested level. Do not wind line all the way onto the spool.
(Be careful not to get caught in the reel.)
Attention
Do not wind the end of the line onto the spool because it causes incorrect length
calculation. Move the power lever to OFF, and wind manually when nearing the end of the
line.
Should “ Err ” appear on the display, then use the MODE SET
BUTTON to re-enter the data.
Line data input
(With backing line---P2)