Daiwa TANACOM BULL 750 - Manual (Page 13)

11
9 Do not reel in the end of the line
MAX
OFF
8
7.
Take off the Input Roller.
8. Pull the Power Lever to the OFF position once again. (The
beep will then be heard.)
9.
Push again the Power Lever forward to maximum and wind the
remaining line to fill the spool.
Be careful not to wind up the end of the line because it may cause
an error.
Line data input
(with Input Roller)
Attention
1.Do not allow line to rub against the finger guard while winding as it will scratch the guard.
2. When the line is wound indoors for a long time (15 min. or more) at a high tension, the
motor may heat up abnormally and cause problems, such as deterioration of winding
power, speed, etc., so electric winding is stopped automatically. Input line at as a high
speed as possible. When actually fishing, there will be no problem because it is cooled
down with sea water, etc. When it stops, wind up manually or pull the power lever back
up and down again towards the MAX side to rewind it and re-input line.
3. Do not wind the end of the line onto the spool because it causes incorrect length
calculation. Move the power lever to OFF, and wind manually when nearing the end of the
line.
OFF
10. Pull the power lever back to the OFF position when only
about 10 m of the line to be wound remains. (This will stop
electric winding.)
(Alarm sound)
11
Should “ Err ” appear on the display, then use the MODE SET
BUTTON to re-enter the data.
11. When the line is wound until the position just before the end,
press the RESET BUTTON RESET BUTTON for more than 2 seconds. When you
hear the alarm sound and the display shows 0.0 0.0, the line data
input is complete.
Line’s end