Daiwa TANACOM BULL 750 - Manual (Page 12)

10
Input Roller
Line data input
(with Input Roller)
You can also set the main line utilizing the Input Roller.
6
1
4
5
MAX
Levelwind Guide
Main line
Pin
Power lever
Input Roller
4. Attach the Input Roller, sold separately, to the reel. You will
then hear a beep sound confirming that the reel enters then into
the Automatic Input mode.
Tighten the drag to give enough line tension in order to wind line
without slipping
1. Run the line through the Level Wind Guide and tie it onto the
spool.
The Levelwind Threader, one of the accessories, makes this
process easier.
Make sure of tying the line onto the Thread Pin to avoid the line
slipping on the spool surface.
2.
Connect the battery to the reel.
3. With the reelʼs power on and the display showing 0.0 ,
press the MODE BUTTON for more than 5 seconds.
5. Push the Power Lever forward to maximum and wind the line.
When the Power Lever is moved forward, number on the lower
rigth portion of the display changes into a tension indicator, and
number of the counter on the upper portion of the display
begins to increase.
Keep line tension between level “ 5 ” and “ 7 ” while winding the line.
6.
Continue line winding until the line touches the Input Roller.
When the line reaches the Input Roller, the latter begins to rotate
so that the winding may stop automatically.
2
OFF
3
4
-Note that the value of tension between 5 and 7 simply displays
an appropriate value with the power lever at MAX. When wound
at a low speed, the display shows that a high tension is applied,
so please be careful since it may cause trouble.
As line winding continues, the displayed number of the counter
increases.
Line data input
With lnput Roller
See animation