Daiwa TANACOM BULL 750 - Manual (Page 25)

23
4. Press the MODE BUTTON to go back to depth readout.
1
2
4
2.
Press MODE BUTTON again.
3. Set speed with the power lever.
The output is set as the pre-set value of the power lever. (After
pre-setting, it memorizes the value of the last change.)
-The winding stops when you press the PICKUP BUTTON while
winding up with the power lever.
1.
Press MODE BUTTON .
3
MAX
OFF
Pickup speed preference
If the display is at display, then move the power lever
or press RESET BUTTON to show the display shown on the
right.
This display is the pickup setting display.
(Pre-set value is 15.)
Use
While the power lever is at MAX position,
pressing the PICKUP BUTTON makes the
motor run at the pre-set pickup speed.
Attention
1. While the PICKUP PICKUP BUTTON is in use for winding, winding speed is not
displayed.
(the figure corresponds
to the case of setting to 5)
Functional setting operation
(5. Pickup speed setting)