Line data input, Backing line 2---p3), Attention – Daiwa TANACOM BULL 750 User Manual
Page 19
17
7
Should “
Err
” appear on the display, then use the
MODE SET
BUTTON
to re-enter the data.
6.
Pull an additional 50m of line from the spool.
7.
Pull out additional 50 m of line and then press the
RESET
BUTTON
for more than 2 seconds. (The line is pulled out for
100 m in total.)
It displays
100.0
and this is the completion of the input procedure.
8.
Wind up the line.
(Apply the auto stop function when winding up using electrical
power.)
Attention
1.
Do not wind the end of the line onto the spool because it causes incorrect length
calculation. Move the power lever to OFF, and wind manually when nearing the end of
the line.
2.When you input data following this procedure, there are cases in which the length of line
will not be displayed if exceeds 100 m, but this is not a problem. In this case, try another
input method.
Line data input
(Backing line 2---P3)