CANOGA PERKINS 9171 Configuration Guide - Manual (Page 90)

CanogaOS Configuration Guide
15-2
DUT# configure terminal Enter the Configure mode
32-bit mask, making it a host address.
DUT(config-if) # exit Exit the Interface mode and return to Configure mode.
DUT(config) # ip route 192.168.0.1/32 10.10.10.1
DUT(config) # ip route 192.168.0.3/32 10.10.12.3
Specify the destination and mask for the network for
which gateway is required and add a gateway for each of
them.
R3
DUT# configure terminal Enter the Configure mode.
DUT(config) # interface loopback 0 Specify loopback as the interface you want to configure.
DUT(config-if) # ip add 192.168.0.3/32 Configure the IP address on this interface and specify a
32-bit mask, making it a host address.
DUT(config-if) # exit Exit the Interface mode and return to Configure mode.
DUT(config) # ip route 0.0.0.0/0 10.10.12.2 Specify 10.10.12.2 as a default gateway to reach any
network. Since 10.10.12.2 is the only route available you
can specify it as the default gateway instead of
specifying it as the gateway for individual network or
host addresses.