CANOGA PERKINS 9145E10G Network Interface Device Hardware - Manual (Page 43)

Operation 9145E10G Ethernet Network Interface Device User’s Manual
Interface Management
31
The following steps describe how to set up HyperTerminal on your PC.
CAUTION: Connect serial cable after PC is booted up. Booting up with the
cable connected may cause the PC to load incorrect driver,
resulting in an erractic curser
1. Select Start>All Programs>Accessories>Communications>HyperTerminal. The New
Connection - HyperTerminal window will open.
2. Enter a name for the connection to the system in the Name box, select an icon to identify
this connection on your desktop, and click OK. The Connect To window will open.
3. Select COM from the Connect using drop down menu, and click OK. The Com1 Proper-
ties window will open.
4. At the COM 1 Properties window, on the Port Settings tab, select the following from the
appropriate dropdown menus, then Click Apply:
• Bits per second: 9600 bps
• Data bits: 8
• Parity: None
• Stop bits: 1
• Flow control: None
5. Click OK. HyperTerminal connects to the system and VT100 terminal emulation starts.
6. In the Hyperterminal window, select the Properties button from the tool bar, select the
Settings tab, select VT100 from the Emulation drop down menu, and click OK.
7. Default username is admin
8. Default password is admin (case sensitive)