CANOGA PERKINS 9145E10G Network Interface Device Hardware User Manual
Page 31
Installation
9145E10G Ethernet Network Interface Device User’s Manual
Mounting Options
19
Mounting Two 9145E10Gs, Side by Side, in a 19" or 23" Rack - To rack mount two
9145E10Gs, perform the following steps:
1. Install the 19" Dual Unit or 23" Dual Unit Rack Mount Bracket Kit. The Rack Mount Kit
includes two rack mount brackets, two center brackets, a strap, a rear bracket, and the
screws required to attach the brackets to the 9145E10Gs. The mounting brackets attach
to the two threaded holes on the outside of each 9145E10G, toward the front (see Figure
3-3). The two center brackets attach to the two threaded holes on the inside of each
9145E10G, and the strap mounts over the front of each center bracket (see Figure 3-5).
The rear center bracket is attached to the threaded holes at the top inside corner of the
back of each 9145E10G (see Figure 3-6).
2. Place unit with brackets attached in place on the desired mounting rack.
3. Install two screws through each bracket into the threaded holes of the mounting rack (see
Figure 3-7). Torque the screws to the rack manufacturer’s specifications.
Figure 3-7. Mounting Two 9145E10Gs on Rack
Figure 3-5. Install Center Brackets and Strap
Figure 3-6. Install Rear Center Bracket
USER PORT
RESET
POWER
STATUS
9145E1
0G-527
L/A
SPD
10GXFP