CANOGA PERKINS 9145E10G Network Interface Device Hardware - Manual (Page 41)

Operation 9145E10G Ethernet Network Interface Device User’s Manual
Power-Up and Front Panel Functions
29
4.1.2 XFP, SFP and UTP Port Status LEDS
The Speed (SPD) and Link/Activity (L/A) LEDs are located above the XFP, SFP and UTP Ports of
each port section (see Figure 4-1). See Table 4-2 to determine the current condition of these
ports.
Table 4-2. User and Network Port LED Indicators
LED Name State Condition
SPD
Off Port Disabled
Green 10GBase Full
Amber System Test
Red Remote Fault
Blinking Red Invalid/Unsupported XFP installed
Slow Blinking Green* Port Enabled but No Link
L/A
Off
No link
No transmit or receive activity
Green Link on with full duplex
Blinking Green Transmission or receiving activity with full duplex
Amber System test
Red
Port Disabled
LLF
Blinking Red No Link, but transmitting OAM packets in unidirectional mode
* Slow Blinking Green means the LED toggles between OFF and GREEN approximately once per
second.