CANOGA PERKINS 9145E10G Network Interface Device Hardware - Manual (Page 21)

Functional Description 9145E10G Ethernet Network Interface Device User’s Manual
Port Default Settings
9
2.5 Port Default Settings
Table 2-2 represents the default settings for each of the ports. The term active connector refers to
the connector, either UTP, SFP or XFP, that is currently enabled. For example, if a particular
9145E10G model has a User Port with both UTP and SFP connectors present, by default the
UTP is the Active Connector (it can currently transmit and receive data), while the SFP is the
Inactive Connector (i.e., it currently cannot transmit or receive data).
Table 2-2. Default Port Settings
NOTE:Cells in yellow denote which of the connectors are active by default
2.6 Power Connectors
Both 9145E10G models will accommodate both single and redundant AC and DC powering
options, along with mixed AC and DC powe.
2.6.1 Power Requirements
18 VDC to 36 VDC, 2.0 Amps for 24VDC power supply
36 VDC to 72 VDC, 1.0 Amps for 48VDC power supply
100 VAC to 240 VAC (auto-ranging), 50/60 Hz, , 1.0 Amp
2.6.2 Single AC Power Base Unit
The Single AC powered 9145E10G (see Figure 2-5) has an IEC 320 power connector on the rear
panel. An appropriate AC power cord is supplied with the unit.
Figure 2-4. Single AC Power
UTP
SFP w/ Multispeed Optics
(100 to 1000)
XFP w/ 10GigE Optics
User Port N/A N/A Auto
Network Port N/A N/A Auto
Multipurpose Port Auto 100 FD N/A
Mgmt UTP port Auto 100 FD N/A