CANOGA PERKINS L351 10/100BASE Media Converter - Manual (Page 30)

EdgeAccess Universal Chassis System
L351 10/100BASE Media Converter 4-11
Alarm Description
4) LLF Link loss forwarded to module; default if Off
5) Configuration Setup errors, including mismatches with other modems; default
is Off
6) Power/Fan/Temperature Power is low or fan is off; default is Minor
7) SBMC Loss
Sideband management signal lost; default is Off
8) Power-On Self Test Modem failed when power was turned on; default is Off
Note: You must enable the Alarm Output item on the System Status & Configuration screen for
these settings to take effect.
4.5.5 SNMP Configuration
If the L351 is in a Model 1020, use the IP/SNMP Agent Configuration screen to view and set up the
SNMP parameters on the L351. To view SNMP parameters, see Figure 23 and Table 6 and follow
these steps:
1. From the System Configuration menu type
5
, "IP/SNMP Configuration," and press . The
SNMP Configuration screen appears.
2. Type the number for the alarm you want to set and press .
3. Type the information or value, and press .
4. To return to the System Configuration menu, press .
IP/SNMP AGENT CONFIGURATION
Local Remote
MAC Address 00 40 2A 00 87 E3 00 40 2A 00 53 E7
Management Port UP UP
1) Ethernet IP Address 172.016.148.030 172.16.143.10
Subnet Mask 255.255.000.000 255.255.0.0
Default Gateway 000.000.000.000 172.16.1.1
2) SLIP/PPP IP Address 000.000.000.000 192.0.0.83
3) Serial Port Config VT100 VT100
4) BOOTP Disabled Disabled
5) Telnet Security Disabled Disabled
6) Host Table
7) Trap Table
8) Inband Management Port Both Ports
9) Management VLAN Disabled
10) Management VLAN Number 1
Figure 23. IP/SNMP Agent Configuration Screen