Storix Software SBAdmin AIX System Recovery Guide User Manual
Page 25
Storix System Backup Administrator
25
Version 8.2 AIX System Recovery Guide
operating system files, or if the operating system on the backup was missing files necessary for normal
system operation. Refer to the error messages provided and correct the problem before continuing the
installation.
c58
The user is being prompted to change the key switch to allow for normal system boot
The key switch is set to the SERVICE position and must be changed to the NORMAL position in order
to reboot the system from disk after completion of the installation.
200
The system key is in secure mode when booting
Power off, turn the key to SERVICE and power on again.
510
Configuring base system devices during a tape boot
511
then
blank screen
Console configured but messages cannot be displayed
The cfgcon command successfully configured a system console device, however the console
messages fail to appear because of missing or incorrect device support for the graphic adapter. You
must install the appropriate device support on the system from which the backup tape was made before
creating the System Backup.
512
Configuring additional system devices during a tape boot
Restoring installation files from tape during a tape boot
600
Network boot has started
602
Configuring base system devices during a network boot
603
Configuration of base system devices failed during a network boot
If this error occurs, base system device support is probably missing from the network boot image.
Ensure that all required device support for the client is installed on the boot server and remake the
network boot image.
604
Configuring network boot device
605
Boot device is invalid during a network boot
The bootinfo -B command failed due to device support missing from the boot image which is required to
support the system's hardware. The problem usually is caused from missing SCSI or BUS device
support. You will need to remake the network boot image on the server after installing all device
support required for the system to be installed.
606
Bringing up network boot device
608
Copying client installation settings from boot server to client
609
Failed to copy client installation settings from boot server to client
This error may occur if the client installation settings are missing from the boot server. Check the file
/storix/netboot/client.bootinfo (where ‘/storix’ is the SBAdmin data directory and ‘client’ indicates
the name of the client to boot). This error may occur if:
1. The file does not have read permissions for all users.
2. The file does not exist.