Chemtronics Static Free Floor Finish ES567 - Manual (Page 2)

USAGE INSTRUCTIONS
Make sure floor is stripped of previous floor
finish, and has been rinsed and cleaned. Pour
the Static Free™ Floor Finish into a clean
bucket. Immerse a rayon or other mop
designed for floor finish application into the
finish. Ring mop slightly, place on the floor
and apply in a figure eight motion. Repeat
until entire area has been coating. Allow
Static Floor Finish at least 30 minute drying
before adding additional coats.
AVAILABILITY
ES167 1 gallon container
ES567 5 gallon container
TECHNICAL & APPLICATION
ASSISTANCE
Chemtronics provides a technical hotline to
answer your technical and application related
questions. The toll free number is: 1-
800-TECH-401.
ENVIRONMENTAL IMPACT DATA
ENVIRONMENTAL IMPACT DATA
CFC 0.0% VOC 9.0%
HCFC 0.0% HFC 0.0%
CL Solv. 0.0% ODP 0.0
CFC, HCFC, CL. SOLV., VOC, and HFC numbers
shown are the content by weight. Ozone depletion
potential (ODP) is determined in accordance with the
Montreal Protocol and U.S. Clean Air Act of 1990.
The ODP of this product is 0.0. It is the sum of the
ODP of the substances that may contribute to the
depletion of stratospheric ozone, based upon the
weight of each substance in the product’s
formulation.
NOTE:
This information is believed to be accurate. It is
intended for professional end users having the skills
to evaluate and use the data properly.
CHEMTRONICS does not guarantee the accuracy of
the data and assumes no liability in connection with
damages incurred while using it.
Chemtronics® is registered trademarks of Chemtronics. All rights reserved.
Static Free™ is a trademark of Chemtronics. All rights reserved.
All other trademarks herein are trademarks or registered trademarks of their
respective owners.
CHEMTRONICS
8125 COBB CENTER DRIVE
KENNESAW, GA 30152
1-770-424-4888
REV. C (08/13)
DISTRIBUTED BY: