Chemtronics CircuitWorks 5 Minute Conductive Epoxy CW2400J - Manual

PRODUCT DESCRIPTION
CircuitWorks

Conductive Epoxy is a two
part, silver epoxy used in prototype, repair
and general conductive bonding
applications. CW2400 features strong
mechanical bonds, excellent electrical
conductivity, and quick room temperature
curing. CircuitWorks

Conductive Epoxy
bonds aggressively to a wide variety of
materials.
 Two-component product
 Simple mixing ratios
 Excellent electrical conductivity
 Fast curing
 High strength bond
 Bonds dissimilar surfaces
 Operating temperature range from
 -91
°C (-131°F) to 100°C (212°F)
TYPICAL APPLICATIONS
CircuitWorks

Conductive Epoxy may be
used for electronics applications including:
 Conductive Bonds Between Heat
Sensitive Components
 Solderless Surface Mount Connections
 Circuit Board Trace Repair
 Static Discharge and Grounding
 Solder Repair
 Conductive Structural Adhesions
TYPICAL PRODUCT DATA AND
PHYSICAL PROPERTIES
Composition
Material Part A Epoxy
Part B Hardener
Specific Gravity 4.0
(Parts A & B Mixed)
Cured Compound
Volume Resistivity <0.001 ohm-cm
Thermal Conductivity
Cal-cm/sec-cm
2
-
°C 3.8 x 10 -3
BTU-in/hr-ft
2
-
°F 11.0
W/m
°K 1.6
Operating Temperature -131 to 212
°F
Range (-91 to 100
°C)
Lap Shear >1200 lbs/in
.
(ASTM D-1002)
Shore Hardness >70
Dropping Point None @ 650
°F
(ASTM D-2266) (343
°C)
Adhesion Excellent
Cured Flexibility Excellent
Chemical Resistance Excellent
Moisture Resistance Good
Typical Thickness 5 mil
Shelf life 9 months
Conditions: Store at temperatures below 77
° F
TDS # CW2400
CHEMTRONICS
Technical Data Sheet
CircuitWorks

Conductive Epoxy