Chemtronics Soder-Wick Unfluxed SD 75-4-10 - Manual (Page 2)

USAGE INSTRUCTIONS
For industrial use only.
Read MSDS carefully prior to use.
1) Choose a Soder-Wick

desoldering braid width
equal to or slightly larger than the pad or
connection.
2) Choose a solder iron tip equal to or slightly
larger than the pad or connection.
3) Set temperature of iron between 600-750
°F
4) Place wick on solder joint and place tip of hot
iron on top of wick
5) As solder becomes molten, the color of the wick
will change from copper to silver.
6) Remove wick and iron from solder joint
simultaneously once color change has stopped.
7) The component lead / pad is now clean and free
from solder.
8) Clip and discard the used portion of the wick.
9) If needed, clean PCB with CircuitWorks

Flux
Remover Pen and remove soils with a
ControlWipes
 absorbent wipe.
SODER-WICK

IS DESIGNED TO MEET
OR EXCEED THE FOLLOWING:
MIL-F-14256F, Type R
NASA-STD-8739.3
DOD-STD-883E, Method 2022
ANSI/IPC J STD-004, Type ROL0
BELLCORE TR-NWT-000078
ANSI/IPC J SF-818
SODER-WICK

SD BOBBINS ARE
DESIGNED TO MEET OR EXCEED:
MIL-STD-2000A
MIL-B-81705C
MIL-STD-1686C
MIL-HDBK-263B
TECHNICAL & APPLICATION
ASSISTANCE
Chemtronics provides a technical hotline to
answer your technical and application
related questions. The toll free number is:
1-800-TECH-401.
AVAILABILITY
Series:
40 Soder-Wick

Lead-Free, SD Bobbin
50 Soder-Wick

Rosin
80 Soder-Wick

Rosin, SD Bobbin
60 Soder-Wick

No Clean, SD Bobbin
70 Soder-Wick

Unfluxed
75 Soder-Wick

Unfluxed, SD Bobbin
VacuPak

Packaging
The VacuPak Can contains ten five-foot bobbins
in a vacuum sealed can. This package provides
the highest level of cleanliness and freshness.
Great for tool kit storage.
HELPFUL HINTS:
Water Soluble Users: Use Soder-Wick

Unfluxed 70 or 75 Series to dip in water soluble
flux and then desolder normally.
Ball Grid Array: Use Soder-Wick

BGA with a
large tipped iron to remove solder from a number of
BGA pads all at once.
NOTE: This information is believed to be accurate. It
is intended for professional end users having the skills to
evaluate and use the data properly. CHEMTRONICS

does not guarantee the accuracy of the data and assumes
no liability in connection with damages incurred while
using it.
Chemtronics
, Soder-Wick and CircuitWorks are
registered trademarks of Chemtronics. All rights reserved.
VacuPak
 and ControlWipes are trademarks of
Chemtronics. All rights reserved.
Chemtronics
8125 Cobb Center Drive
Kennesaw, GA 30152
1-770-424-4888
REV. F (08/13)
DISTRIBUTED BY: