Chemtronics Flux-Off Rosin ES5535 - Manual

PRODUCT DESCRIPTION
The Flux-Off

Rosin formulation is a fast
drying aerosol that quickly and completely
removes R, RMA, RA, and synthetic flux
residue. With its low surface tension and
superior wetting properties, Flux-Off

Rosin
removes harmful residues in tight tolerance
areas.
 Removes R, RMA, RA, and synthetic flux
residues
 Penetrates hard to reach areas
 Evaporates quickly
 Leaves no residue
 Removes oil, grease, ionic and non-ionic
residues
 Has low odor
 Non-corrosive formulation
 Contains no CFCs or HCFCs
TYPICAL APPLICATIONS
Flux-Off

Rosin removes flux residues and
cleans:
 Chip Carriers
 Heat Sinks
 Plugs
 Printed Circuit Boards
 Relays
 Sockets
 Surface Mount Device Pads
 Switches
TYPICAL PRODUCT DATA AND PHYSICAL
PROPERTIES
Boiling Point
141
°F Initial
Solubility in Water 20%
Specific Gravity 0.70
Evaporation Rate (butyl acetate=1) >1
Surface Tension
(dynes/cm @21.6
°C)
17.3
Flash Point (TCC) -20.0
°F
Kauri-Butanol (KB) Number 50
VOC* Content: Aerosol Liquid
CARB 75% 100%
SCAQMD 603 g/L 720 g/L
Federal 75% 100
%
RoHS Compliant
Shelflife Aerosols 5 years
Liquids 2 years after opening
*Volatile Organic Compound (VOC) information is calculated on a
weight basis using the VOC definition of California Air Resources
Board (CARB) Consumer Product Regulations, South Coast Air
Quality Management District (SCAQMD) Rule 102 and the Federal
definition published in 40 CFR 51.100(s).
COMPATIBILITY
Flux-Off

Rosin is generally compatible with
most materials used in the electronics
industry. With any cleaning agent
compatibility solvent/component must be
determined on a non-critical area prior to use.
TDS # 1035
CHEMTRONICS
Technical Data Sheet
Flux-Off

Rosin Flux Remover