Chemtronics CircuitWorks Water Soluble Flux Dispensing Pen CW8300 User Manual

Page 2

COMPATIBILITY
CircuitWorks



Water Soluble Flux Pen is

generally compatible with most materials
used in the electronics industry. As with any
cleaning agent, material compatibility should
be determined on a non-critical area prior to
use.

USAGE INSTRUCTIONS
For industrial use only.
Read MSDS carefully prior to use.

Flux Application: Water Soluble Flux should
only be applied to areas to be soldered. Hold
pen vertically, touch surface of PCB and
briefly depress tip to start liquid flow.

Lightly wipe pen tip over surface to be
fluxed. Use a ControlWipe

 dry wipe to

remove flux buildup.

Cleaning: Flux residues must be removed
after soldering as they are conductive and
corrosive. No neutralizer, saponifiers or
detergent are necessary for complete removal
of flux residues. It is not recommended to use
high mineral content tap water, therefore
deionized or softened water may be used for
cleaning. The optimum water temperature is
54-66

C (130-150

F). Chemtronics Flux-

Off



Water Soluble may also be used as a flux

remover.

TECHNICAL & APPLICATION
ASSISTANCE
Chemtronics provides a technical hotline to
answer your technical and application related
questions. The toll free number is: 1-800-
TECH-401.

AVAILABILITY
CW8300 9 gm (0.32 oz) Flux Pen

ENVIRONMENTAL IMPACT DATA

ODP

None

VOC

Yes

HCFC

None

HFC

None

Ozone depletion potential (ODP) is determined in accordance with the Montreal
Protocol and U.S. Clean Air Act of 1990. Hydrochlorofluorocarbons (HCFCs)
are regulated under the Montreal Protocol as Class II ozone depleting substances.
Volatile Organic Compound (VOC) information is calculated on a weight basis
using the VOC definition of California Air Resources Board (CARB) Consumer
Product Regulations, South Coast Air Quality Management District (SCAQMD)
Rule 102 and the Federal definition published in 40 CFR 51.100(s).
Hydrofluorocarbons (HFCs) are not currently regulated.

NOTE:

This information is believed to be

accurate. It is intended for professional end
users having the skills to evaluate and use the
data properly.
CHEMTRONICS does not guarantee the
accuracy of the data and assumes no liability
in connection with damages incurred while
using it.

CHEMTRONICS
8125 COBB CENTER DRIVE
KENNESAW, GA 30152
1-770-424-4888

Rev. B (08/13)

Chemtronics

, Flux-Off and CircuitWorks are registered



DISTRIBUTED BY: