Chemtronics CircuitWorks® Flex Conductive Pen CW2900 - Manual (Page 2)

CircuitWorks® Flex Conductive Pen
2. Hazards identification
See toxicological information (Section 11)
Medical conditions
aggravated by over-
exposure Pre-existing disorders involving any target organs mentioned in this MSDS as being at
risk may be aggravated by over-exposure to this product. :
Fertility effects : No known significant effects or critical hazards.
Over-exposure signs/symptoms
Ingestion : Adverse symptoms may include the following:
headache
drowsiness/fatigue
unconsciousness
Skin : Adverse symptoms may include the following:
irritation
redness
Eyes : Adverse symptoms may include the following:
irritation
watering
redness
Inhalation : Adverse symptoms may include the following:
drowsiness/fatigue
nausea or vomiting
headache
respiratory tract irritation
Target organs : Contains material which causes damage to the following organs: eye, lens or cornea.
Contains material which may cause damage to the following organs: kidneys, lungs,
mucous membranes, peripheral nervous system, upper respiratory tract, skin, central
nervous system (CNS), nose/sinuses, testes.
silver (Metallic) 7440-22-4 45 - 65
2-methoxy-1-methylethyl acetate 108-65-6 10 - 30
n-butyl acetate 123-86-4 10 - 30
butanone 78-93-3 3 - 15
3. Composition/information on ingredients
Name CAS number %
There are no additional ingredients present which, within the current knowledge of the supplier and in the
concentrations applicable, are classified as hazardous to health or the environment and hence require reporting
in this section.
Wash out mouth with water. Do not induce vomiting unless directed to do so by medical
personnel. Never give anything by mouth to an unconscious person. Get medical
attention immediately.
Check for and remove any contact lenses. Immediately flush eyes with plenty of water
for at least 15 minutes, occasionally lifting the upper and lower eyelids. Get medical
attention immediately.
In case of contact, immediately flush skin with plenty of water for at least 15 minutes
while removing contaminated clothing and shoes. Wash clothing before reuse. Clean
shoes thoroughly before reuse. Get medical attention immediately.
Move exposed person to fresh air. If not breathing, if breathing is irregular or if
respiratory arrest occurs, provide artificial respiration or oxygen by trained personnel.
Loosen tight clothing such as a collar, tie, belt or waistband. Get medical attention
immediately.
4. First aid measures
Eye contact
Skin contact
Inhalation
Ingestion
:
:
:
:
2/11 4011 6/27/2013.