Regulatory information, Other information – Chemtronics CircuitWorks® Boron Nitride Heat Sink Grease CW7250 User Manual
Page 7

CircuitWorks® Boron Nitride Heat Sink Grease
15. Regulatory information
Australia inventory (AICS): Not determined.
China inventory (IECSC): Not determined.
Japan inventory: Not determined.
Korea inventory: Not determined.
Malaysia Inventory (EHS Register): Not determined.
New Zealand Inventory of Chemicals (NZIoC): Not determined.
Philippines inventory (PICCS): Not determined.
Taiwan inventory (CSNN): Not determined.
International regulations
International lists
:
Canada inventory
:
Not determined.
Chemical Weapons
Convention List Schedule
I Chemicals
:
Not listed
Chemical Weapons
Convention List Schedule
II Chemicals
:
Not listed
Chemical Weapons
Convention List Schedule
III Chemicals
:
Not listed
New York
:
None of the components are listed.
New Jersey
:
None of the components are listed.
Pennsylvania
:
None of the components are listed.
16. Other information
Hazardous Material
Information System (U.S.A.)
1
0
0
0
0
1
National Fire Protection
Association (U.S.A.)
Health
Special
Instability/Reactivity
Flammability
Health
Flammability
Physical hazards
CONTAINS MATERIAL THAT MAY CAUSE TARGET ORGAN DAMAGE, BASED ON
ANIMAL DATA.
Label requirements
:
:
:
Caution: HMIS® ratings are based on a 0-4 rating scale, with 0 representing minimal hazards or risks, and 4
representing significant hazards or risks Although HMIS® ratings are not required on MSDSs under 29 CFR 1910.
1200, the preparer may choose to provide them. HMIS® ratings are to be used with a fully implemented HMIS®
program. HMIS® is a registered mark of the National Paint & Coatings Association (NPCA). HMIS® materials may
be purchased exclusively from J. J. Keller (800) 327-6868.
The customer is responsible for determining the PPE code for this material.
Reprinted with permission from NFPA 704-2001, Identification of the Hazards of Materials for Emergency
Response Copyright ©1997, National Fire Protection Association, Quincy, MA 02269. This reprinted material is not
the complete and official position of the National Fire Protection Association, on the referenced subject which is
represented only by the standard in its entirety.
7/8
CW7250
1/2/2014.