Chemtronics CircuitWorks® Boron Nitride Heat Sink Grease CW7250 - Manual (Page 4)

CircuitWorks® Boron Nitride Heat Sink Grease
8. Exposure controls/personal protection
Use a properly fitted, particulate filter respirator complying with an approved standard if
a risk assessment indicates this is necessary. Respirator selection must be based on
known or anticipated exposure levels, the hazards of the product and the safe working
limits of the selected respirator.
Safety eyewear complying with an approved standard should be used when a risk
assessment indicates this is necessary to avoid exposure to liquid splashes, mists or
dusts. If contact is possible, the following protection should be worn, unless the
assessment indicates a higher degree of protection: safety glasses with side-shields.
Personal protective equipment for the body should be selected based on the task being
performed and the risks involved and should be approved by a specialist before
handling this product.
Personal protection
Eyes
Skin
Respiratory
:
:
:
Chemical-resistant, impervious gloves complying with an approved standard should be
worn at all times when handling chemical products if a risk assessment indicates this is
necessary. Considering the parameters specified by the glove manufacturer, check
during use that the gloves are still retaining their protective properties. It should be
noted that the time to breakthrough for any glove material may be different for different
glove manufacturers. In the case of mixtures, consisting of several substances, the
protection time of the gloves cannot be accurately estimated. Hands :
Hygiene measures : Wash hands, forearms and face thoroughly after handling chemical products, before
eating, smoking and using the lavatory and at the end of the working period.
Appropriate techniques should be used to remove potentially contaminated clothing.
Wash contaminated clothing before reusing. Ensure that eyewash stations and safety
showers are close to the workstation location.
Environmental exposure
controls : Emissions from ventilation or work process equipment should be checked to ensure
they comply with the requirements of environmental protection legislation. In some
cases, fume scrubbers, filters or engineering modifications to the process equipment
will be necessary to reduce emissions to acceptable levels.
Solid.
White. Off-white. [Light]
9. Physical and chemical properties
Physical state
Color :
:
The product is stable.
No specific data.
Under normal conditions of storage and use, hazardous decomposition products should
not be produced.
No specific data.
10. Stability and reactivity
Chemical stability
Conditions to avoid
Incompatible materials
Hazardous decomposition
products
:
:
:
:
Possibility of hazardous
reactions : Under normal conditions of storage and use, hazardous reactions will not occur.
11. Toxicological information
Acute toxicity
Silica, amorphous, fumed,
cryst.-free LD50 Oral Rat 3160 mg/kg -
Product/ingredient name Result Species Dose Exposure
Conclusion/Summary : Not available.
Chronic toxicity
Conclusion/Summary : Not available.
Irritation/Corrosion
4/8 CW7250 1/2/2014.