Ix. pairing the fob to the quickdraw system – WEATHER GUARD Model QDSKSA01 Quick Draw Kit, Saddle Box User Manual

Page 18

Page 18

ENGLISH

Ix. pairing the fOB to the QuickDraw System

NOTE: FOB memory is cleared every time the system begins

learning mode. In this case, all corresponding FOBs will need to be

re-paired by following sequence below.
The QuickDraw FOB comes pre-paired to the system module. Re-

pairing of the FOBs to the system module will be required in the

following scenarios: When adding additional FOBs or if the module

is accidently put into learning mode.

a. To program more than 3 FOBs (up to 10 total) see step d. (iv)

b. Lost or stolen FOB (all systems FOBs must be re-paired at the

same time) to program a FOB to the QuickDraw system:
1. Ensure DIP switches are in correct position (Factory Settings):

Factory

Settings

DIP

Position

OFF

2. Enter “Learning mode” by locating and pressing the programming

button 3x until red LED activates (see Figure 23)

4. Press Button 1 on the QuickDraw FOB, the LED indicator will

flash and then remain solid

5. The FOB has now been paired
6. System will automatically exit Learning Mode within 30 seconds

c. To pair multiple FOBs to QuickDraw system module:

figure 23