WEATHER GUARD Model 8908-3 Parts Cabinet, 8 Drawer - Manual

1
PARTS CABINET
Models 8906-3 • 8908-3 • 8909-3 • 8918-3
ATTENTION: PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS AND WARNINGS
BEFORE ASSEMBLING, INSTALLING OR USING THIS PRODUCT.
Danger of explosion. Do not use this product for stor ing or transporting flammables, exp losives, hazardous materials, or hazardous waste, such as
containers of gasoline, solvents, gun powder, dynamite, propane tanks, acetylene tanks and cutting torches. Failure to heed this warning will result
in death or serious injury.
DANGER
This product is only intended and safe for use in storing and transporting small tools, equipment and other similar materials. These instructions are
to be followed using the parts and fasteners supplied for proper installation. Any modifications or improper installation of this product will create a
hazardous condition that could result in death, serious personal injury and/or property damage.
All floor mounting bolts near the fuel tank area should be installed from the underside of the vehicle, to guard against the fuel tank being punctured in
the event of a collision. This would mean not using Blind Fasteners in this area. Holes in this area should be 5/16". Ensure ample space in roof ribs
and sidewall ribs for mounting screws so as not to puncture exterior roof or wall.
Do not install this product where it could interfere with deployment of air bags. Failure to comply could result in death or serious body injury.
WARNING
WWW.WEATHERGUARD.COM
VAN STORAGE SOLUTIONS
INSTALLATION TIME
Approximate installation time: 12 minutes per unit (0.2 hours) depending on van equipment installation experience.
– NOTICE –
Any modification or unintended use of this product shall immediately void all manufacturers warranties. Manufacturer disclaims all liability for injuries
to persons or property resulting from any modification to, or unintended use of this product.
CAUTION
Prior to drilling, so as not to cut electric wires, fuel lines, brake lines, etc., check behind and underneath drilling and mounting locations. To keep debris
out of your eyes when checking the underside of the vehicle, or when drilling, always wear protective eye wear. Failure to heed this warning will result
in death or serious injury.
BOLT KIT
FOR THE WAY YOU WORK™
Part No. 24-0063 Rev B 11/11 (ECN 5026)
Bolt Kit #3522 is provided with your product. Check this bolt kit to be sure
the following parts are included:
NOTE: Depending on your application you may end up with extra
hardware after installation is complete.
DESCRIPTION
BOLT KIT
#3522 QTY.
1/4-20 Nylon Lock Nut 10
1/4-20 x 1/2" Hex Head Bolt 10
TOOLS REQUIRED
• 7/16" Open or Box End Wrench (2)
• Pencil or Marker
• Electric Drill with 5/16" Drill Bit
INSTALLATION MANUAL
*24-0063*