WEATHER GUARD Model 8867-3-01 Work Top, Steel, 1-1/2 in x 42 in x 18 in - Manual

PAGE IF YOU HAVE ANY QUESTIONS, PLEASE CONTACT US TOLL-FREE AT .800.456.7865
PARTS
Item Qty. Description
A 1 Work Top
1 Bolt Kit #32-0101
INSTALLATION MANUAL
WORKTOP MODEL 8867
ATTENTION: PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS AND WARNINGS BEFORE ASSEMBLING, INSTALLING OR USING THIS PRODUCT.
These instructions are to be followed using the parts and fasteners
supplied for proper installation. Any modifications or improper
installation of this product will create a hazardous condition that
can cause property damage, serious personal injury or death. Any modification or unintended use of this product shall immediately
void all manufacturers warranties. Manufacturer disclaims all liability
for injuries to persons or property resulting from any modification
to, or unintended use of this product.
Approximate Assembly and Installation Time:
20 min. (.3 hours) depending on van equipment
installation experience.
WARNING – NOTICE –
1 NOTE: The unit(s) this work top is to be
mounted on, must be the correct width or
properly spaced to accept the mounting
method.
Place the Work Top in position and mark the
center point of the bolt holes that will require
fastening.
NOTE: Mark center of bolt hole carefully
since an off-center Blind Fastener makes
installation difficult.
Remove work top and drill where marked
with 1/8" drill bit for pilot holes. Redrill
holes to enlarge them, using a 13/32"
drill bit. Install Blind Fasteners. (See
INSTALLATION INSTRUCTIONS
FOR BLIND FASTENERS on page 2).
Attach Work Top using four (4) 1/4-20 x 3/4"
Hex Head Bolts and 1/4" Lock Washers.
INSTALLATION IS NOW COMPLETE.
A
TOOLS REQUIRED
• Electric Drill
• Drill Bits: 13/32", 1/8"
• Open End Wrenches: 7/16", 9/16"
Part No. 24-0244 REV. B ECN 5305 04/13