WEATHER GUARD Model QDSKSA01 Quick Draw Kit, Saddle Box - Manual (Page 14)

Page 14
ENGLISH
VI. System Check
Testing the QuickDraw Remote (FOB)
The QuickDraw starter kit comes complete with 1 FOB, which
is pre-programmed to the System module included. If additional
FOBs are desired for the system, please see “FOB programming”.
a. Test 1: Proximity hands-free operation
1. Bring the QuickDraw remote into range (within 5ft of
box).
2. Ensure truck box lid is closed and all push button locks are
in locked position.
3. Test one of the QuickDraw proximity function by depressing
and holding push button lock for approximately 2 seconds.
• If truck box opens correctly, proceed to test push the
other button lock. If both push button locks work correctly,
proceed with test 2.
• If truck box does not open correctly, double-check all
electrical connections and repeat testing.
e. Attach the (4) pin connector on the battery harness to the system
module and feed the other end of the harness out of the box through
the hole in the box partition, down the inside of the gas strut guard
and exit the box through the 12v access grommet hole located on
the driver side end of the box. See Figure 18. Run the harness
to the truck battery and cut to length. Crimp the proper size ring
terminal to each wire and apply heat to the insulation to shrink tight
to the wires. Attach the red wire to the positive battery terminal and
the black wire to the negative battery terminal.
figure 18
BATTERY HARNESS
SADDLE BOX
HARNESS