WEATHER GUARD Model QDSKSA01 Quick Draw Kit, Saddle Box - Manual (Page 13)

Saddle Box
USER INSTRUCTIONS
Page 13
ENGLISH
b. Place the QuickDraw system module on the driver side of the box,
but do not fasten in place. See Figure 16.
c. Plug the saddle box harness into the system module using the four
(4) pin connector. Plug into the connector labeled saddle box per
system module diagram.
d. Using locking rod cover plate (removed in step a.) from the driver
side end of the box, attach the antenna to the center of the cover
plate using small velcro disks (supplied) Figure 17. Run the antenna
wire parallel to the saddle box harness and plug the (2) pin connector
into the system module as shown in Figure 13.
figure 16
figure 17