Satellite MX3 Wet Lift - Manual (Page 3)

PN 17152 REV F 10-22-10
13) Start threaded ends of cables into turnbuckles so cables
from the front & rear form an X pattern. Make sure the two (2)
left-hand 104.25” long cables (green colored at male end of
cable match the green colored female ends of
turnbuckles).Tighten cables by turning turn buckles with an
adjustable wrench (be very careful not to force and cross-
thread turnbuckles when tightening cables & do not over
tighten cables, cables should be taut) Install 6” Wire Tie
through both turnbuckles and tighten.
Tip: can use locking pliers & adjustable wrench to hold
cables while tightening turnbuckles.
14) Plug eight (8) 1/2 “holes using expandable rubber inserts
and screws. Tighten screws with flat blade screw driver while
holding insert flange to expand rubber barrel. Note: if cable is
not positioned correctly in 3/16” holes inserts will not fit.
2530 Xenium Lane North, Minneapolis, MN 55441
Telephone: 763-553-1900 Fax: 763-553-1905
800-328-3332 / www.satelliteindustries.com