Satellite MX3 Turbo SS Bowl - Manual (Page 2)

19628 REV C 2
7. Fasten hose to plate fill/pump out with hose clamp. SEE FIG #7
8. Drill out hole in rear panel. If using a hole saw, use a 5-1/2’ hole saw and use dimple in panel for starting point. If
using a jig saw, cut out outside edge of the recess. SEE FIG #8
9. Insert the large hose into the 1-1/2” [38mm] hole in base. Note the curvature of the hose goes downward and fits
into the hole in the base hole without kinking. SEE FIG #9
10. Fasten plate to panel. Using the plate as a fixture, drill out a one of the holes with a #10 [5mm] drill bit. BEING
CAREFUL TO JUST DRILL THROUGH FIRST LAYER. Fasten plate to panel with rivet and repeat step to (3)
remaining holes in plate. SEE FIG #10
11. Push plug in plate hole. SEE FIG #10
12. Apply Icon and decal to door and panel.
Luxury
Flush & Wash
2530 Xenium Lane North, Minneapolis, MN 55441
Telephone: 763-553-1900 Fax: 763-553-1905
800-328-3332 / www.satelliteindustries.com