Satellite MX2 Wet Lift User Manual

Page 2

PN 15208 REV D Page 2 11-14-11

Slip 5/8" flat washer and 5/8" lock washer over the threaded end of the sling and fasten with 5/8” nut. Repeat on (3)

remaining (See Figure D) Note: “Do NOT use an impact wrench to tighten”.

Insert a cotter pin through holes in the end of the sling. Bend pin ends to secure.

Set unit upright.

10.

Slide the serial rating name plate onto spreader bar. (See Figure F)

11.

Thread 3/4” nut on each end of the spreader bar and turn until they are to the end of the threads.

12.

Insert the spreader bar through the hole in retainer. Keep the flanged edge away from the nut. (See Figure F)

13.

Insert the spreader bar through the sling at the narrowest point. The sling will fit into the retainer. (See Figure E)

14.

Put on (2) 3/4” washers, then a 3/4” nut on spreader bar and tighten. Put on the other 3/4” nut and tighten. Repeat on

opposite side. (See Figure F)

Note: The spreader bar should be just touching against the roof when the nuts are tightened.

NOTE: When lifting by crane or etc., lift only by the ring end of each sling.

15. Place decal on each side panel as shown.

2530 Xenium Lane North, Minneapolis, MN 55441

Telephone: 763-553-1900 Fax: 763-553-1905

800-328-3332 / www.satelliteindustries.com