Petsafe Stay+Play Wireless Fence PIF17-13478 - Manual (Page 11)

www.petsafe.net 11
DE
NL
IT
FR
ES
EN To Set the Static Stimulation Level
Read all the steps below before attempting to set the Static Stimulation Level. Refer to the Function and Response
Table below for advice on setting the Static Stimulation Level that best suits your pet.
1. Press the Mode Button and release (
3B) when the Receiver Indicator Light illuminates Red (3C).
2. The Receiver Indicator Light will emit a series of Red flashes representing the Static Stimulation Level.
3. Increase the Static Stimulation Level by pressing and releasing the Mode Button within 5 seconds of the
previous series of flashes.
The Static Stimulation levels increase in strength from 1 to 6. Pushing the Stimulation Level Button while the
Receiver Collar is on level 6 will cause the Receiver Collar to revert to level 1.
Function and response Table
Indicator Light
response
Static
Stimulation
Level
receiver Collar Function Temperament of Pet
1 Red Flash 1 No Static Stimulation, Tone Only Initial Training Mode
2 Red Flashes 2 Low Static Stimulation Timid
3 Red Flashes 3 Medium-Low Static Stimulation Timid or Average
4 Red Flashes 4 Medium Static Stimulation Average Energy
5 Red Flashes 5 Medium-High Static Stimulation Average or High Energy
6 Red Flashes 6 High Static Stimulation High Energy
Over Stimulation Protection
If your pet enters the Boundary Zone or continues anywhere beyond the Pet Area, this feature limits the Static
Stimulation duration to 15 seconds. While the system locks out further Static Simulation, the green light will remain
on for 10 seconds.
In the unlikely event that your pet leaves the Pet Area, he will not receive a Static Stimulation upon return to the
Pet Area.