Outdoor Great Room Intrigue Table Fire Pit - Manual (Page 9)

Page | 9 Intrigue 90215 REV E 6/7/2012
D. LP Gas Supply

The pressure regulator and hose assembly supplied must
be used. Replacement pressure regulators and hose
assemblies must be those specified in this manual.

The LP gas supply cylinder used with LP models must be
constructed and marked in accordance with the
specifications for LP gas cylinders of the U.S. Department
of Transportation (DOT).

Cylinders must be stored outdoors in a well-ventilated area
out of the reach of children. Disconnected cylinders must
have threaded valve plugs tightly installed and must not
be stored in a building, garage or any other enclosed
area.

Storage of this appliance indoors is permissible only if it has
been disconnected from its fuel supply
 The LP gas cylinder supply system must be arranged for
vapor withdrawal.

The LP gas cylinder used must include a collar to protect the
cylinder valve.

When not in use, the LP gas must be turned off at the supply
cylinder.

The specific size and capacity of the cylinder(s) to be used:
INTRIGUE-1: 1lb screw-on cylinder
INTRIGUE-20: 20lb or larger with OPD connection
4
Setting up the Intrigue
A. Burner Assembly - Before you begin-
 Check for damage. Do not use damaged
components.
 If there is evidence of excessive abrasion or wear,
or if the hose is damaged, the hose assembly
must be replaced prior to the appliance being put
into operation. Use only the replacement hose
assembly specified by the manufacturer.
 If it is evident that the burner is damaged, the
burner must be replaced prior to the appliance
being put into operation. Use only the
replacement burner assembly specified by the
manufacturer.
 Position the assembly in the desired location. You
must have easy access to the on/off switch
included with this product.
 Make sure the tank valve is turned completely off
(clockwise).
 Ensure the tank valve has the proper external
mating
threads (tank valve marked “USE WITH TYPE 1”).
 Inspect the hose shipped with the appliance for
any
damage. Do not use if there is evidence of
damage.
 A hose is included with your kit, ensure that it
is securely tightened to the fitting on the
bottom of your Intrigue before attaching hose
to tank.
 Connect the regulator assembly to the tank valve.
Hand-tighten only (clockwise). Do not use a wrench
to tighten! Use of a wrench may damage the quick
closing nut and result in a hazardous condition.
 Position the hose out of pathways where people
might trip over it or in areas where the hose
might be subject to accidental damage.
Before setting up the Intrigue:
Make sure the table or mounting surface chosen
contains a hole 1 1/2”-2 3/4” in diameter for proper
installation clearance and fastening.