Outdoor Great Room Gallery Wall-Mounted Fireplaces - Manual

90238 Rev B 11/8/12
Gallery Wall-Mounted Fireplaces
Installing the fireplace into a wall as a built-in unit
Included in this kit-

Wall Mounting Brackets (2)

M5x10 Screws (4)

Control button relocation module (1)
Tools Required-

Philips Screwdriver or
power drill with
Philips tip (preferred)

Leveling device
NOTE: Heater unit may be removed or left attached to the fire box for this installation. Use the provided
diagrams for clearances for each configuration.

Removing the heater unit (optional)

Remove 4 screws from underside of heater unit

Unplug the heater from the fire box by
squeezing the tabs on the white quick
connector plug and pulling downward. Set
heater assembly aside or dispose of
appropriately.
Remove

Relocate Heat and lighting controls

Remove the screws holding the access panel on
the underside of the fire box on.

There is a small quick connect plug inside this
access panel. Plug the control module (included
with this kit) into the quick connect plug and
screw access panel back into place, threading
wire through hole in access panel door.

Once fireplace is installed into a wall, the
control button module can be mounted to the
wall surface below it using a screw or a
double-sided adhesive strip.
Connect control button module to
fire box
Remove screws