Outdoor Great Room Intrigue Table Fire Pit - Manual (Page 11)

Page | 11 Intrigue 90215 REV E 6/7/2012
3
a.
Brass
fittings
Step 5:
Connect the wires hanging from the Burner
Module to the Control Module as shown at
right.
Connect the wire with the small tip to the
port labeled S
Connect the wire with the large tip to the
port labeled I
Tighten
Step 3:

Slide the Control Module up the threaded rod (through the holes shown at lower left)

Thread a wingnut onto the threaded rod to hold it in place while performing the next step.

Insert brass fitting into the hole in the top of the Control Module.

Using two wrenches, fully tighten the connection.
3
c.
3
b.
(Shown with battery pack removed)
I S
5.
Attach wingnut
(snug to bottom of bracket
after completing step 3c.)