Outdoor Great Room Intrigue Table Fire Pit - Manual (Page 15)

Page | 15 Intrigue 90215 REV E 6/7/2012
A. This appliance must be lit electronically. When
lighting, follow these instructions exactly.
B. Before lighting, smell all around the appliance area
for gas. Be sure to smell next to the base of the
appliance because some gas is heavier than air and
will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:

Do not try to light any appliance.

Do not touch any electric switch, do not use any
phone nearby.

Immediately call your gas supplier from a neighbors
phone. Follow gas supplier’s instructions.

If you cannot reach your gas supplier, call the fire
department
FOR YOUR SAFETY, READ BEFORE LIGHTING
WARNING!
If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury, and/or loss of life.
C. Use only your hand to turn the gas control knob
on propane tank (if equipped) , never use tools. If
the valve won’t turn by hand, don’t try to repair it,
call a qualified service technician. Force or
attempted repair may result in a fire or explosion.
D. Do not use the appliance if any part has been
underwater. Immediately call a qualified service
technician to inspect the appliance and replace any
part which has been underwater.
E. The gas pressure regulator provided with this
appliance must be used. This regulator is set for an
outlet pressure of 10.5 inches water column.
Lighting Instructions
1. STOP! Read the safety information above.
2. Open propane tank valve (if equipped)
3. Locate three-position switch and set to ON
position (I)
4. Burner should beep twice and begin sparking.

During first use, it may take longer than
usual for flame to ignite due to air being
present in gas line. This is normal.

If sparking stops before flame ignites, turn
the unit to the OFF position (O) and consult
troubleshooting section of this manual (P.15)
5. To extinguish, put switch in OFF position.
Manual Ignition
6. STOP! Read the safety information above.
7. Open propane tank valve (if equipped)
8. Locate three-position switch and set to REMOTE
position (II)
9. If using remote for the first time you will need to
program it to work with your Intrigue.

Using a toothpick or other small instrument,
depress the button on the remote receiver
(located in the hole directly adjacent to the
LED that flashes when the unit is turned on)
until a beep is heard.

Immediately press and hold the “set” button
on your remote until two beeps are heard.
This confirms remote has been programmed.
10. Burner should beep twice and begin sparking.

During first use, it may take longer than
usual for flame to ignite due to air being
present in gas line. This is normal.

If sparking stops before flame ignites, turn
the unit to the OFF position (O) and consult
troubleshooting section of this manual (P.15)
11. To extinguish, press ON/OFF button on remote.
Remote Setup and Ignition
NOTE:
This device contains an intelligent flame recognition system
which will produce a spark until the presence of a flame is
detected. Ensure that burner area and sensing/igniting
electrodes are kept clear for proper operation.